Makita 12 Compound Sliding Miter Saw Manual

The Makita 12 Compound Sliding Miter Saw is designed for precision cutting and versatility in woodworking projects. It features a powerful motor, a dual slide system for smooth operation, and an adjustable miter and bevel for various cutting angles. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 12-inch blade, dual bevel capability, laser guide, and dust collection system.

Feature	Description
12-inch Blade	Provides a wide cutting capacity for various materials.
Dual Bevel	Allows for bevel cuts in both directions for added versatility.
Laser Guide	Helps ensure accurate cuts by projecting a line on the workpiece.
Dust Collection	Integrated system to minimize debris and keep the workspace clean.
Powerful Motor	Delivers consistent performance for demanding tasks.

Installation

Unpack and inspect contents. Place the saw on a stable work surface.

Secure the saw to the workbench using the provided clamps.
Connect to a power source: Ensure the voltage matches the saw's requirements.
Install the blade: Follow the instructions in the manual for proper installation.
Adjust the miter and bevel settings as needed.

WARNING! Ensure all safety guards are in place before operating the saw.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

Calibrate the laser guide for accurate alignment.
Test the miter and bevel adjustments to ensure smooth operation.
Familiarize yourself with the controls and safety features.

CAUTION! Always wear appropriate safety gear when operating the saw.

Specifications

Blade Diameter: 12 inches.
Motor Power: 15 Amp.
Bevel Capacity: 0° to 45° left and right.
Miter Capacity: 0° to 52° left and right.
Weight: 57 lbs.
Dust Port Diameter: 1-1/2 inches.
Voltage: 120V.

Controls and Settings

Access the miter and bevel adjustments using the knobs located on the saw.

Safety Features: Electric brake, blade guard, and anti-kickback design.

Ensure all settings are locked before making cuts.

Connecting Devices

Ensure the saw is unplugged before making any adjustments or connections.

Connect a dust collection system if desired.
Use appropriate extension cords for power supply.

Tip: Always check connections before operating the saw.

Operating the Saw

Follow these steps for safe operation:

Adjust the miter and bevel settings as needed.
Power on the saw and wait for the blade to reach full speed.
Make your cut, keeping hands clear of the blade.
Power off the saw after use and unplug it.

WARNING! Never reach over the blade while it is in motion.

Safety Features

Includes blade guard, electric brake, and anti-kickback design to enhance user safety.

Care & Cleaning

Unplug the saw before cleaning. Use a dry cloth to remove dust and debris.

CAUTION! Do not use liquids or solvents to clean the saw.

Regulatory Information

This saw complies with all applicable safety standards and regulations. For support, visit www.makitatools.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Blade does not spin	Power supply issue	Check power connection and circuit breaker.
Laser guide not visible	Battery issue	Replace the battery in the laser guide.
Inaccurate cuts	Calibration	Recalibrate the miter and bevel settings.
Excessive vibration	Loose parts	Check and tighten all screws and bolts.

Reset: Follow the manual instructions for resetting the saw if necessary.

Service: For service inquiries, contact 1-800-4-MAKITA or visit www.makitatools.com.