Makita Compound Sliding Miter Saw Manual

The Makita Compound Sliding Miter Saw is designed for precision cutting of wood, plastic, and other materials. It features a powerful motor, adjustable miter angles, and a sliding mechanism for increased cutting capacity. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Maintenance 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Sliding mechanism, adjustable miter and bevel angles, laser guide, and dust collection system.

Feature	Description
Sliding mechanism	Allows for wider cross cuts and increased cutting capacity.
Laser guide	Provides precision cutting lines for accuracy.
Bevel adjustment	Allows for angled cuts up to 45 degrees.
Dust collection	Helps keep the workspace clean by collecting sawdust.
Powerful motor	Delivers high performance for various cutting tasks.

Installation

Unpack and inspect contents. Place on a stable work surface.

Ensure the saw is on a flat surface and securely fastened.
Connect the dust collection system if applicable.
Adjust the miter and bevel settings as needed.
Plug into a power source.

WARNING! Ensure all safety precautions are followed during installation.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

Adjust the blade height for the material being cut.
Set the miter angle for the desired cut.
Test the laser guide alignment before cutting.

CAUTION! Always wear safety gear when operating the saw.

Specifications

Blade Size: 10 inches.
Motor Power: 15 Amps.
Cutting Capacity: 12 inches at 90 degrees.
Miter Angles: 0-52 degrees left and right.
Bevel Angles: 0-45 degrees left.
Weight: 42 lbs.
Dust Port: 2-1/2 inches.

Controls and Settings

Access settings via the control panel. Features include miter adjustment, bevel adjustment, and power switch.

Safety Features: Blade guard, electric brake, and safety switch.

Connecting Devices

Ensure the saw is unplugged before making any connections.

Connect the dust collection system to the dust port.
Ensure all cables are secured and not in the way of the cutting area.

Tip: Always check connections before operating the saw.

Operating the Saw

Follow these steps for safe operation:

Power on the saw and allow it to reach full speed.
Position the material and secure it with clamps if necessary.
Make the cut using a steady motion.
Power off the saw after use.

WARNING! Keep hands away from the blade at all times.

Safety Features

Includes blade guard, electric brake, and safety switch to prevent accidental starts.

Care & Maintenance

Unplug before cleaning. Regularly check and replace the blade as needed.

CAUTION! Do not use abrasive cleaners; keep the saw away from moisture.

Regulatory Information

Meets safety standards for power tools. For support, visit www.makitatools.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power connection	Check power source and connections.
Blade not spinning	Motor issue	Inspect motor and switch for faults.
Inaccurate cuts	Misalignment	Check and adjust miter and bevel settings.
Excessive vibration	Loose parts	Tighten all screws and bolts.

Reset: Refer to the manual for reset instructions if available.

Service: Contact Makita customer service for assistance.