Makita Sliding Compound Miter Saw Manual

The Makita Sliding Compound Miter Saw is designed for precision cutting of wood, plastic, and other materials. It features a powerful motor, dual bevel capability, and a laser guide for enhanced accuracy. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Sliding mechanism for wider cuts, dual bevel capability, laser guide, adjustable miter settings, and ergonomic handle.

Feature	Description
Sliding mechanism	Allows for wider crosscuts and increased cutting capacity
Dual bevel	Enables bevel cuts in both directions for versatility
Laser guide	Helps ensure accurate cuts by projecting a line on the workpiece
Adjustable miter settings	Allows for precise angle cuts from 0° to 60°
Ergonomic handle	Designed for comfort and reduced fatigue during use

Installation

Unpack and inspect contents. Place the saw on a stable work surface.

Ensure the work area is clean and well-lit.
Secure the saw to a workbench or stand if necessary.
Connect to a power source, ensuring the voltage matches the saw's requirements.
Check all adjustments and settings before use.

WARNING! Always wear appropriate safety gear when operating the saw.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

Adjust the blade height and angle as needed.
Calibrate the laser guide for accuracy.
Test the saw on scrap material before making final cuts.

CAUTION! Ensure all safety features are engaged before operation.

Specifications

Blade Size: 10 inches.
Motor Power: 15 Amp.
Bevel Capacity: Dual bevel (0° to 45°).
Miter Capacity: 0° to 60° left and 0° to 52° right.
Weight: 42.5 lbs.
Laser Guide: Yes, included.
Power Source: 120V AC.

Controls and Settings

Access settings via the adjustment knobs for bevel and miter angles. The front panel includes power and laser activation buttons.

Safety Features: Blade guard, electric brake, and safety switch.

Connecting Devices

Ensure the saw is unplugged before making any connections.

Connect to a power source using a suitable extension cord if necessary.
Ensure all cables are secured and away from cutting area.

Tip: Use a dedicated circuit to avoid power overload.

Operating the Saw

Follow these steps for safe operation:

Adjust the miter and bevel settings as required.
Place the material securely against the fence.
Power on the saw and allow the blade to reach full speed before cutting.
Make the cut smoothly and steadily.
Power off the saw after use and unplug it.

WARNING! Keep hands away from the blade at all times.

Safety Features

Includes a blade guard, electric brake, and safety switch to prevent accidental starts.

Care & Cleaning

Unplug the saw before cleaning. Use a dry cloth to remove dust and debris.

CAUTION! Do not use liquids or solvents on the saw.

Regulatory Information

This product complies with applicable safety standards and regulations. For support, visit www.makitatools.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Blade not spinning	Power issue	Check power source and connections.
Laser not working	Battery issue	Replace laser guide batteries.
Inaccurate cuts	Calibration	Recalibrate the saw settings.
Excessive vibration	Blade issue	Check blade for damage or misalignment.

Reset: Refer to the manual for reset instructions if available.

Service: Contact Makita customer service for assistance.